Deco Mesh Witch Wreath Tutorial


DIY- Deco Mesh Witch Wreath

This is such a cute deco mesh witch wreath, don’t you think? And it is so easy and fun to do.

Deco Mesh Witch Wreath

Super cute Halloween decoration for your front door. And really easy to do.

Have you ever wanted to buy a handmade wreath but just couldn’t justify spending upwards of $75.00?  I’ve been there for sure! Fortunately I have a creative side and do a lot of hand-made projects my self.  But the thing is you really don’t even have to be creative to make your own deco mesh witch wreath…it really is so easy and there really isn’t a right or wrong way of doing it.  I found a wreath very similar to this one going for $135.00…I made this one for under $30 and if I would have planned it a little better I could have done it for under $20…but I was too impatient to wait for the 50% off coupon at the craft store.

Time to go shopping for the supplies:

  • 12 inch wire wreath ring (Dollar Tree)
  • Pipe Cleaners – orange or black would be best (I forgot to stock up so I had to use some yellow)
  • 10 inch gold or bronze glitter deco mesh (Craft Store)
  • 5 inch black Ribbon or deco mesh
  • 3 inch orange wire ribbon
  • witches legs (I got mine from Walmart…but the craft stores have them too)
  • Witches hat (with or without the hair)
  • Broom (mine is from Dollar Tree)
  • Hot Glue Gun

witch-wreath-supplies

Cut your gold glitter mesh into 5 x 5 inch  squares and your ribbons into 5 inch lengths…none of these have to be exact…close enough is OK!  I used 40 of each but you could more if you want. Cut your pipe cleaners in half.

witch-wreath-cutting-mesh

witch-wreath-cutting-mesh

witch-wreath-cut-mesh

Start with the Gold mesh on the bottom creating a gather effect, add the black and then the orange gathering as you layer. Then add another layer of each so you will have a total of six layers. Take your pipe cleaner to secure making a pom-pom. Make sure the ends of the pipe cleaner is in opposite direction to the ends of the ribbon.

witch-wreath-gather-mesha witch-wreath-twist-tie-mesha

 

Choose a starting point on your wire wreath form. From here you just keep repeating making the pom-pom and securing to the wreath form. As you add your pom-pom be sure to alternate which wire section you are adding to so that you get a somewhat even fullness all the way around the ring.

witch-wreath-beginninga

witch-wreath-back-ties

The back of the wreath.

The finished wreath will be the body of the witch.

The finished wreath will be the body of the witch.

Time to heat that glue gun!  While it you wait for the glue gun to heat up do a dry run by setting up the legs, broom and hat where you want to glue them.  For mine the legs also came with the skirt so I had to play with them a little to get them to lay the way I wanted them to. I also tried a couple different ways to do the hat.

And Voila you have a super cute deco mesh witch wreath…and at a fraction of the cost of buying one. I would love to know how yours turns out…leave me a comment below. If you thought this was easy to follow please be sure to pin it to Pintrest.

If you like this tutorial be sure to check out this Christmas wreath tutorial as well

http://creativetable.net/easy-diy-christmas-wreath/

easy DIY Christmas Wreath

DIY Poly Mesh Christmas Wreath

 

Please follow and like us:

Tell me what you think